$1,099.00
Telstra Cel-Fi Go Smart Repeater Kit 3G/4G/4GX for Boats and other Caravan applications. Includes an RFI Omni Directional Antenna with ratchet mount (folds down) and stick on internal coverage Panel Antenna.
Whether you’re travelling on the water or camping in a remote area and tired of cruising through dead zones of data service, or you’re planning your next big motor home or 4WD trip, a 3G/4G/4GX mobile repeater is the ultimate tool for you !
Supported Networks – Telstra, Aldi Mobile, Boost Mobile, Woolworths Mobile
Many drivers find that in remote areas, calls on their phones are constantly dropping and internet speeds are at an all-time low. Our 3G/4G / 4GX mobile repeater work to eliminate these annoyances when travelling by:
With just these three steps, your 3G/4G / 4GX mobile repeater will increase the quality of your mobile services with crystal clear calls and reliable service and reception – dropped calls and slow internet speeds will be a thing of the past!
FEATURES:
SUITABLE FOR:
Telstra Go Smart Repeater Mobile model is based on the Nextivity’s Cel-Fi GO Mobile Phone Repeater and has been tested, authorized and approved by Telstra for use on the Telstra Mobile Network.
Telstra Go Smart Repeater is a one box coverage solution for Telstra’s Next G® and 4GX networks operating on 3G 850Mhz or 4G 700/1800MHz bands. It is designed to dramatically boost voice quality and increase data speeds for in vehicle applications.
Telstra Go Smart Repeater offers a more flexible installation over other Cel-Fi models due to the abilty to run cables to where the signal is needed most. By not having a wireless link between two boxes GO can operate in areas that are saturated with Wi-Fi.
Telstra Cel-Fi Go Smart Repeater Mobile Boat/Caravan Kit 3G/4G/4GX is suitable for boat and caravan applications and includes an Omni Directional Antenna with ratchet mount (folds down) and Coverage Panel Antenna.
Out to Sea Coverage (from www.telstra.com.au)
Telstra’s 850MHz Next G network can typically extend 20 to 70 km out to sea from mobile base stations located near the coast. However, there are many factors such as the weather, tides, sea conditions and your antenna installation (type and height above sea level) that can significantly influence coverage, data speed and performance. As a result, you must not rely on the Telstra Mobile Network as a primary method of communication at sea.
To assist with your mobile services at sea, you should use a directly connected external antenna – one that is omni-directional or a specialist marine antenna capable of ‘tracking’ to the best serving base station. The antenna should be mounted as high as possible on your vessel using marine-grade cabling and connections.
In order for a service at sea to work effectively, line of sight to the terrestrial base station is required. This is influenced by the height of the serving base station, land based obstructions and the general topography of the land, which can block signals. Coverage will not be reliable over the horizon from a mobile base station even though it may be usable at times.
EOL replaced by new model THFCOMMS | Telstra Cel Fi Go R41 Boat & Caravan Kit 3G / 4G / 5G RFI CDQ8195-W 6.5db
Out of stock
For Boats and Caravan applications
100dBi of system gain
Includes external and internal antennas
Locked to Telstra’s Mobile Network
Carrier approved
Bluetooth WAVE App for iPhone, Android & Computers
Supported Networks – Telstra, Aldi Mobile, Boost Mobile, Woolworths Mobile
Includes:
Available Frequency Bands (MHz) | Telstra Band 3/8/28 |
Frequency Range | 1800Mhz, 900Mhz and 700Mhz |
RF Gain | 100dB |
RF Connectors | SMA |
Power Supply | + 12V CLA adapter |
Ambient Temp. Range | 0° to 65°C |
Environment | IP54 |
Weight (inc. frame) | 600gm |
Dimensions | 255mm(W) x 87mm(D) x 28mm(H) |
Output Impedance | 50ohms |
Current Consumption | 15W |
DC Supply | 9.6 to 28.8 VDC via external supply |
Case | One piece extruded Aluminium |
Frequency – Layered Navigation | Multiband |
Installation should be carried out strictly in accordance with the Cel-Fi GO Mobile Quick Start Guide and Cel-Fi GO Stationary Quick Start Guide and any other information contained in the box. Vehicle installations of the Cel-Fi Go Mobile in particular requires special attention not to interfere with air bag mechanisms, safety and control systems, ABS, stability and traction systems and the vehicles auto electrics in general. You should be familiar with applicable federal and state regulations and industry standards regarding installation. Incorrect installation may result in water leaks, electrical damage, fusing and risk of fire. Misuse of this equipment or failure to follow the instructions in the Quick Start Guide could result in injury and equipment damage. In no event will Comnet Solutions be responsible or liable for either indirect or consequential damage or injury that may result from the installation or use of this equipment. Please contact our Support Team if you have any questions regarding the above precautions. Call (02) 6680 7949 and ask for Telstra Smart Repeater support or email [email protected] .In no event will THFCOMMS be responsible or liable for either indirect or consequential damage or injury that may result from the installation or use of this equipment. Please contact our Support Team if you have any questions regarding the above precautions. 02 6680 7949 , Should be installed by a licensed auto electrician.
more info on this product @ data sheet
Specifications are subject to change without notice. Picture may not be exact model as described.
Before using this product you will need to download mobile app and register before first use .
You must be logged in to post a review.
Reviews
There are no reviews yet.